Every moisture problem has a different source. We identify yours specifically before we quote anything — then we deploy the right system, not the most expensive one.
💧
Sub-Slab Interior Drainage Installation
When hydrostatic pressure is the primary culprit, the most effective long-term solution is a properly engineered interior drainage system. We install sub-slab perforated drain tile around the perimeter of your basement — capturing water before it can rise above slab level — and route it to a sump pit equipped with a dual-pump configuration.
Our sub-slab drainage systems use schedule 40 perforated PVC pipe in a stone bed, designed to handle high-volume water tables.
📞 Get a Free Drainage Quote →
🏗️
Exterior Foundation Coating & Drainage Board Installation
Exterior waterproofing is the most comprehensive solution available — stopping water before it contacts your foundation wall. We excavate to the footing, apply a rubberized polymer membrane to the exterior foundation face, install dimple-mat drainage board, and backfill with clean crushed stone to redirect surface water away from the structure.
We use SilkOate, UMARK, and other commercial-grade membrane systems — not the paint-on damp-proofing that deteriorates within a few years.
📞 Schedule an Exterior Assessment →
🔧
Foundation Crack Injection — Polyurethane & Epoxy Systems
We inject poured-wall cracks using a port-and-backer system: surface ports are installed at 8–12 inch intervals along the crack, the surface is sealed with hydraulic cement, and two-part polyurethane or epoxy is pumped under pressure from the lowest port up — filling the crack through its full depth.
Block wall repointing involves removing deteriorated mortar joints to a minimum depth of 3/4 inch and repacking with waterproof hydraulic mortar.
📞 Get a Crack Injection Estimate →
🌿
Crawl Space Encapsulation & Vapor Barrier Systems
We install a minimum 20-mil reinforced poly vapor barrier over the entire crawl space floor and seal it up the walls to the sill plate — then seal all vents, install a conditioned air supply or dedicated crawl space dehumidifier, and spec a sump system if groundwater is present.
For crawl spaces with active water entry, we install a perimeter drain channel at the footer line, route it to an appropriate discharge point or sump.
📞 Schedule a Crawl Space Inspection →
⚙️
Sump Pit Construction & Dual-Pump Waterproofing Systems
The sump pit itself matters as much as the pump. We construct 18-inch diameter pits with a gravel bed at the base for proper water collection, sealed lids to prevent vapor and radon entry, and a discharge line that terminates a minimum of 10 feet from the foundation at a positive-grade daylight point.
For finished basements and properties with high groundwater, we recommend a dual-pump system: a primary submersible at normal operating level and a pedestal backup set two inches higher.
📞 Get a Sump System Quote →
🪟
Egress Window Waterproofing & Well Cover Systems
We excavate and regrade window wells to the proper dimension, install a gravel drain bed with a perforated pipe tied into your perimeter drainage system, and apply waterproof flashing around the window frame — stopping the entry point at the source instead of managing it inside.
Egress window installations create a significant opening in your foundation wall, and sealing the rough opening properly is as important as the window itself.
📞 Book a Window Well Assessment →
